Nokia Bluetooth Headset BH-108
4
2
1
3
5
6
7
8
9
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
software subject to export laws and
regulations from the US and other
countries. Diversion contrary to law is
prohibited.
Introduction
With the Nokia Bluetooth Headset
be in line of sight, but they should
BH-108, you can make and answer be within 10 metres (33 feet) of
calls hands-free with your
compatible mobile device.
each other. Connections may be
subject to interference from
obstructions, such as walls, or other
electronic devices.
Read this user guide carefully before
using the headset. Also, read the
user guide for the device that you
connect to the headset.
The headset is compliant with
Bluetooth Specification 2.0 + EDR
supporting the Headset Profile 1.1
and Hands-Free Profile 1.5. Check
with the manufacturers of other
devices to determine their
This product may contain small
parts. Keep them out of the reach of
small children.
The surface of this device is nickel-
free.
compatibility with this device.
Bluetooth wireless technology
Bluetooth wireless technology
allows you to connect compatible
devices without cables. The headset
and the other device do not need to
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
3
Get started
Warning: Use only
The headset contains the following
parts shown on the title page:
earpiece (1), indicator light (2),
multifunction key (3), earloop (4),
charger connector (5), and
microphone (6).
chargers approved by
Nokia for use with this
particular model. Theuse of
any other types may
invalidate any approval or
warranty, and may be
dangerous. Use of
unapproved chargers may
present a risk of fire,
Before using the headset, you must
charge the battery and pair the
headset with a compatible device.
explosion, or other hazard.
Parts of the device are magnetic.
Metallic materials may be attracted to
the device. Do not place credit cards or
other magnetic storage media near the
device, because information stored on
them may be erased.
When you disconnect the power cord
of any accessory, grasp and pull the
plug, not the cord.
1. Connect the charger to a wall
outlet.
Charge the battery
Before charging the battery,
carefully read “Battery and charger
information”.
2. Connect the charger cable to the
charger connector. The red
indicator light is displayed
during charging. Charging the
battery fully may take up to 2
hours.
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
4
3. When the battery is fully
charged, the green indicator
light is displayed. Disconnect the
charger from the headset, then
from the wall outlet.
Switch on or off
To switch on, press and hold the
multifunction key for about 2
seconds. The headset beeps, and the
green indicator light is displayed.
The headset tries to connect to the
last used device. When the headset
is connected to a device and is ready
for use, the green indicator light
flashes slowly. If the headset has not
been paired with a device, it
The fully charged battery has power
for up to 5 hours of talk time or up
to 120 hours of standby time.
To check the battery charge when
the headset is not connected to a
charger, press the multifunction key
when the headset is connected to a
mobile device. If the indicator light
is green, the charge level is
sufficient. If the light is yellow, you
may need to recharge the battery
soon. If the light is red, recharge the
battery.
automatically enters pairing mode.
To switch off, press and hold the
multifunction key for about 5
seconds. The headset beeps, and the
red indicator light is briefly
displayed. If the headset is not
connected to a device within about
30 minutes, it switches off
automatically.
When the battery charge is low, the
headset beeps every 5 minutes and
the red indicator light flashes.
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
5
3. Within about 3 minutes, activate
the Bluetooth feature on your
device, and set it to search for
Bluetooth devices. For details,
see the user guide of your mobile
device.
Pair and connect the headset
Before using the headset, you must
pair and connect it to a compatible
device.
You can pair the headset with up to
eight devices, but you can connect
it to only one device at a time.
4. Select the headset from the list
of found devices.
1. Make sure your mobile device is
switched on and the headset is
off.
5. Enter the passcode 0000 to pair
and connect the headset to your
device. In some devices, you may
need to make the connection
separately after pairing.
2. If the headset has not been
previously paired with a device,
switch on the headset. The
headset enters pairing mode, and
the green indicator light starts to
flash quickly.
When the headset is connected to
your device and is ready for use, the
green indicator light flashes slowly.
To manually connect the headset to
the last used device, press and hold
the multifunction key for about 2
seconds, or make the connection in
the Bluetooth menu of your device.
If the headset has been
previously paired with a device,
make sure the headset is
switched off, and press and hold
the multifunction key for about 5
seconds until the green indicator
light starts to flash quickly.
You may be able to set your device
so that the headset connects to it
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
6
automatically. To activate this
feature in a Nokia device, modify
the paired device settings in the
Bluetooth menu.
Basic use
feature with the headset), when no
call is in progress, press the
multifunction key twice.
Place the headset on the ear
The headset is ready to be used on
the right ear. To use the headset on
the left ear, attach the earloop to
the headset so that it is to the left of
the Nokia logo (9).
To activate voice dialling (if your
mobile device supports this feature
with the headset), when no call is in
progress, press and hold the
multifunction key for about 2
seconds. Proceed as described in the
user guide of the mobile device.
Slide the earloop behind your ear
(7), and gently push the earpiece
against your ear. Push or pull the
earloop to set its length. Point the
headset towards your mouth (8).
To answer or end a call, press the
multifunction key. To reject a call,
press this key twice.
Calls
To make a call, use your mobile
device in the normal way when the
headset is connected to it.
To adjust the volume, use the
volume controls on the connected
device.
To redial the number you last called
(if your mobile device supports this
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
7
To switch a call from the headset to settings are cleared, the headset
a compatible device, press and hold enters pairing mode.
the multifunction key for about 2
seconds, or switch off the headset.
To switch the call back to the
headset, press and hold the
multifunction key for about 2
seconds, or switch on the headset.
To reset the headset if it stops
functioning, even though it is
charged, connect the headset to a
charger while you press and hold
the multifunction key.
Troubleshooting
Clear settings or reset
If you cannot connect the headset
to your compatible device, make
sure the headset is charged,
switched on, and paired with your
device.
To clear all the settings from the
headset, switch off the headset, and
press and hold the multifunction
key for about 8 seconds. The headset
beeps twice, and the red and green
indicator lights alternate. After the
Battery and charger information
This device has an internal,
nonremovable, rechargeable battery.
use when supplied with power from
the following chargers: AC-3, AC-4,
Do not attempt to remove the battery AC-5, AC-8, DC-4, and DC-9. The exact
from the device as you may damage
the device. This device is intended for
charger model number may vary
depending on the type of plug. The
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
8
plug variant is identified by one of the Always try to keep the battery between
following: E, EB, X, AR, U, A, C, K, B, or
UB. The battery can be charged and
discharged hundreds of times, but it
will eventually wear out. Recharge
15°C and 25°C (59°F and 77°F).
Extreme temperatures reduce the
capacity and lifetime of the battery. A
device with a hot or cold battery may
your battery only with Nokia approved not work temporarily. Battery
chargers designated for this device.
performance is particularly limited in
temperatures well below freezing.
If a battery is being used for the first
time or if the battery has not been used Do not dispose of batteries in a fire as
for a prolonged period, it may be they may explode. Dispose of batteries
necessary to connect the charger, then according to local regulations. Please
disconnect and reconnect it to begin
charging the battery. If the battery is
completely discharged, it may take
several minutes before the charging
indicator light is displayed.
recycle when possible. Do not dispose
as household waste.
Never use any charger that is damaged.
Operating times are estimates only.
Actual performance depends on many
factors such as device settings
selected, device features being used (or
running in the background), battery
condition and ambient temperature.
Unplug the charger from the electrical
plug and the device when not in use.
Do not leave a fully charged battery
connected to a charger, since
overcharging may shorten its lifetime.
If left unused, a fully charged battery
will lose its charge over time.
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
9
Taking care of your device
Your device is a product of superior
design and craftsmanship and should
inside the device and damage
electronic circuit boards.
be treated with care. The following
suggestions will help you protect your
warranty coverage.
•
Do not attempt to open the device.
•
Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.
•
Keep the device dry. Precipitation,
humidity, and all types of liquids or
moisture can contain minerals that
will corrode electronic circuits. If
your device does get wet, allow it to
dry completely.
•
•
Do not use harsh chemicals,
cleaning solvents, or strong
detergents to clean the device. Only
use a soft, clean, dry cloth to clean
the surface of the device.
•
•
Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can be
damaged.
Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.
Do not store the device in high or
cold temperature. High
These suggestions apply equally to
your device, charger, or any accessory.
temperatures can shorten the life
of electronic devices, damage
batteries, and warp or melt certain
plastics. When the device warms to
its normal temperature from a cold
temperature, moisture can form
Recycle
Always return your used electronic
products, batteries, and packaging
materials to dedicated collection
points. This way you help prevent
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
10
uncontrolled waste disposal and
promote the recycling of materials.
Check product environmental
information and how to recycle your
Nokia products at www.nokia.com/
The crossed-out wheeled-bin
symbol on your product,
battery, literature, or
packaging reminds you that
all electrical and electronic
products, batteries, and
accumulators must be taken
to separate collection at the
end of their working life. This
requirement applies in the
European Union. Do not
dispose of these products as
unsorted municipal waste. For
more environmental
information, see the product
Eco-Declarations at
ownload from Www.Somanuals.com. All Manuals Search And Downloa
Copyright © 2010 Nokia. All rights reserved.
11
|