Fireball ST
Mounting Guidelines
3.5 inch Form Factor Drive Mounting
Mounting Screw Tap Locations
The mounting holes on Quantum 3.5-inch form factor hard disk drives allow the drive to be mounted in any
orientation. The figure provided identifies the location of the three mounting holes found on each side of the drive
and the four mounting holes found on the PCB side of the drive. Dimensions given are in inches and millimeters.
Mounting Screw Clearance
Please note that the printed-circuit board assembly (PCBA) is very close to the mounting holes. For mounting #6-
32 UNC screws are recommended. Mounting screws should be no longer than 0.25 inches (6.35 mm) and
maximum torque applied to the screws must not exceed 8 inch-pounds. Clearance from the drive to any other
surface (except mounting surfaces) must be a minimum of 0.05 inches (1.25 mm).
1 of 1
|
Toshiba SD R2612 User Manual
Toastmaster MEFB6B User Manual
TechniSat S1 User Manual
Seagate ST240HM001 User Manual
Seagate Barracuda ST3320630NS User Manual
Samsung SCH N380 User Manual
Samsung Cell Phone SCH R530 User Manual
Panasonic RX D25 User Manual
Panasonic CF VDM732U User Manual
Nokia C5 06 User Manual